Max-power VIP150-HYD User Manual download pdf (Page 19)

VIP 150, Hydraulic with Electronic Controller 25/12/2005

8.5 BRONZE DRIVE LEG:

a) Check the oil in the leg every year, and change if necessary (oil drain plug is under the

anode - copper joint should be changed).

b) The anode should be frequently checked and changed when necessary (At least every

year).

c) When the boat is ashore, check for evidence of fishing line, etc… in the propellers.

d) For prevention of calcium build up on the drive shafts, which would damage the oil seals,

before fitting the propeller(s) cover drive shaft and oil seals, with silicon grease. This should

be done on an annual basis after cleaning of outside of leg.

e) Do not use aggressive solvents as they might damage drive leg seals.

f) Always keep the propellers and tunnel clean.

g) Do not paint the anode.

h) Please contact your closest Max Power distributor for local service points.

8.6 GENERAL:

a) Regularly check that the power cable connections are tightened correctly and that they are

free to move when VIP is going up/down, and that they are in good condition.

b) If the vessel is to remain out of the water for some time, for example dry storage for winter,

the underwater mechanism must be thoroughly rinsed with fresh water, then the thruster

column must be liberally greased.

c) Inspect and repair the hull closing plate gasket for deterioration or missing pieces. Check

and tighten, if necessary, the hull fixing plate bracket screws.

d) Every two years drain the entire hydraulic oil system, clean and replace filters and recharge

the hydraulic system with new oil.

e) Every two years change column seal, part number 52 on parts list.

f) Every five years complete removal of unit and return to factory or authorised dealer for full

service, which include

 Complete overhaul of the unit, replacement of column seal, bearings, bushes oil seals etc

 Service of complete hydraulic oil system including pump, distributor, etc.

For more detailed maintenance procedures, please contact your closest Max Power distributor (See

“

Distributor Contact List

”) for further assistance.

A copy of this manual must remain

on board for consultation.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

Max-power VIP150-HYD User Manual Page 19